Topic: CT decay
Hey,
I have been monitoring my CT ratios as I run factory runs.
I have ten runs done so far and my CT only decayed form 55% to 48%.
I am trying to figure out what is reducing the decay I see.
Already I have figured out that the displayed material ratio for the CT (after being installed in the factory) is a rounded value. Also, the actual amount of materials I am required to use is different because the relation ratio is used to calculate that.
So far it seems I loose about .67% every run. But no where in my extensions does it explain the difference from 1%.
I have a single level in basic factory calibration (1% time eff increase) and a single level in Basic Extensive Mass production (1 additional line).
Any insight into this would be appreciated.